Askoma Screw-in immersion heater AHR-B-C-9.0 9.0 kW for domestic water

SKU: 517900230
Category: Tauchheizkörper
Manufacturers: Askoma

657,67 €

incl. 19% VAT , plus (Paket)

Available immediately
Delivery time: 1 - 5 Workdays (DE - int. shipments may differ)

Description

The screw-in immersion heater is used for heating up domestic and heating water like e.g. as an emergency heater in case of failure of the heat generator, as an additional heating system for air / water heat pumps and solar systems.
Due to its small design, it is ideal for a space-saving installations.
The immersion body is supplied with temperature controller, safety limit thermostat and operation pilot light.The heating body is made up of 3 U-shaped tubular heaters soldered into a pressed brass nipple. The non-heated zone is 150 mm for all capacities.If the switch-off temperature of 110°C is exceeded, the switching device turns off and remains locked in this position. Reset is performed manually and is only possible after the filling pipe has cooled off by approx. 10 K. The unit can be fitted horizontally or vertically. As soon as the screw-in immersion heater is to be put into operation, the heating elements must be entirely covered by liquid and the circulation of the liquid must not be obstructed.
Technical data:>
- integrated power contactor - an additional installation is not required
- change-over switch for manual control or direct control of the electric
heating controller via integrated contactor
- setting range: 0°C up to 85°C
- switch-off temperature: 110°C (0-9 K)
- ambient temperature on switching head: max. 50°C
- thermal switching differential: 11.0 K ± 5.5 K
- fitting thread: R 1½"
- protection class: IP 40 according to EN 60529
- maximum operating pressure: 10 bar
- electrical connection: 230 V a.c. or 3x 400 V a.c.
- material heating rod for industrial and heating water:
Cronifer 1.4529, Ø 8.2 mm
- unheated zone: 150 mm
- design: H 103 mm x W 109 mm x D 93 mm
- electromechanical temperature controller according to DIN 3440
(operation type: Type 2 B, according to EN 60 730-1 / -2-9)
- calibration tolerance: ± 7 K
- time factor in water: < 45 s
- surface load: 8-9 W/cm²
- suitable for continuus operation
- with operating light as standard